1. See Detail

DMG Teco

SKU
DMG Teco
In stock
Quick Overview
  • TECO: Bis-GMA-based resin matrix, starter, additives.
  • DMG Etching Gel: o-phosphoric acid in water (37 %), Aerosil.
Special Price ₹1,225.00 was ₹2,400.00

DMG Teco

TECO is the innovative total-etch bonding system from DMG. Besides its excellent bond strength properties, TECO (= Total Etch Control) stands out thanks to its unique DMG patented single dose application form: the »SilvR dose«. The material is freshly activated by simply pressing on the silver chamber and can be used immediately. Application is carried out in just one step – with one hand, quickly and cleanly

COMPOSITION :-

  • TECO: Bis-GMA-based resin matrix, starter, additives.
  • DMG Etching Gel: o-phosphoric acid in water (37 %), Aerosil.

INDICATIONS :-

  • Light-curing dentine and enamel bonding agent in conjunction with the total etch technique for use with light-curing composites and compomers for direct and indirect restorations of cavity classes I - V.

CONTRAINDICATIONS :-

  • Etching the affected areas of dentine is an important component of the application of the material
  • Do not use the material without dentine etching
  • Do not use with chemically curing composites or compomers
  • Do not use with dual-curing composites or compomers if these are not lightcured
  • Do not use in cases of allergies to any of the components or in the event of contact allergies
  • Do not use directly on exposed pulp or in the case of existing pulpitis.

DIRECTIONS TO USE :-

  • Prepare the cavity in accordance with the general rules for adhesive procedures. Bevel the enamel edges. Note: The use of a rubber dam is recommended
  • In deep cavities in areas close to pulp, provide protection in the form of a suitable liner, e.g. by using a small quantity of calcium hydroxide and a thin layer of glass ionomer cement
  • Etch enamel and dentine with 37 % phosphoric acid gel (e.g. DMG Etching Gel). Start the etching process with the enamel and then expand this to the dentine, if applicable, so that the response time on the enamel is 20 to 60 seconds, while the response time on the dentine does not exceed 15 seconds. Observe the manufacturer’s instructions.
  • Rinse tooth with water for a minimum of 15 s. Remove general water excess. Note: After the etching process, an even moist layer must remain on the dentine surface requiring treatment. If this is not the case, wet the dentine surface with a moistened micro brush
  • Work TECO into the tooth structure generously for 20 seconds using the brush
  • Remove any excess
  • Blow TECO using oil-free air into a thin, even layer until the surface appears evenly moist (approx. 5 s)
  • Light-cure TECO for 10 seconds with a suitable light unit
  • Use the filling material or dental cement according to manufacturer’s instructions and cure with a light-curing unit. Observe the recommended layer thicknesses and light-curing times.

CONTENTS :-

  • 1 x 5ml Bottle.
More Information
Brand N/A
Flavour N/A
Return Policy N/A
Opration / Power Source N/A

Product Faqs

Ask a Question




Ask a Question


Sort by   
    There are no faqs for this topic.
Write Your Own Review
You're reviewing:DMG Teco
Your Rating
  • 1 x 5ml Bottle.

Buy dental products online by verified dental material supplier. Shop Dental supplies, dentist equipments, instruments and products by leading dental products company. Full-Time 100% warranty and denture supplies online.